151
_____________________________________________________________________
8.8 Internal Trigger
______________________________________________________________
Flashing cursor
OFF
Trigger filter is disabled.
ON
In Recorder function mode
Trigger filter is enabled. Filter width: 10 ms
0.1 to 10
In Memory recorder function
Trigger filter is enabled. Filter width (DIV)
4. Move the flashing cursor to the upper limit, and set the
upper limit of the trigger level using the
buttons. The
upper limits must not be smaller than the lower limits, or
the lower limits must not be larger than the upper limits.
5. Move the flashing cursor to the position shown in the
figure below, and set the trigger filter width using the
buttons. (Filter settings are not available for the RMS
Recorder.)
To Next Page
Loading...
