Hioki 8807-01 - Page 185

161
_____________________________________________________________________
8.8 Internal Trigger
______________________________________________________________
Flashing cursor
X
Signal disregarded
0
Low level signal
1
High level signal
Flashing cursor
OFF
Trigger filter is disabled.
ON
In Recorder and RMS function mode
Trigger filter is enabled. Filter width: 10 ms
0.1 to 10
In Memory recorder function mode
Trigger filter is enabled. Filter width (DIV)
3. Move the flashing cursor to the position shown in the
figure below and set the trigger pattern using the
buttons.
4. Move the flashing cursor to the position shown in the
figure below and set the trigger filter width using the
buttons.