296
_____________________________________________________________________
16.2 9447 BATTERY PACK
______________________________________________________________
Power switch
AC adapter connecting terminal
NOTE
When the power switch is ON, the battery charging is not
performed.
Always carry out battery charging at an ambient temperature
between 10
and 40 . Outside this range, not only is the
charging capacity reduced, but also there is a possibility of
reduced performance, electrolyte leakage, degraded compounds
within the battery, or shortening battery life.
Only use the specified 9418-15 AC ADAPTER (SA145A-
1240V-6, SINO AMERICAN) for charging.
16.2.1 Battery Charging with the MEMORY
HiCORDER
When using the 9447 BATTERY PACK and the following
warning message is displayed, recharge them.
"WARNING 620: Battery low"
If not using the 9418-15 AC ADAPTER (SA145A-1240V-
6, SINO AMERICAN) the recharging of the 9447 is not
possible.
1. Connect the AC ADAPTER.
2. When the power switch is OFF, the LED above the
START
button will light in red to start the charging.
3. About 2 hours, the charging is completed and the LED
automatically goes off to end.
To Next Page
Loading...
