62
_____________________________________________________________________
4.8 Extended Status Screen Setup (MEM)
______________________________________________________________
Flashing cursor
Display block, date,
time, and time axis
range are displayed
when the trigger
occurs.
1
2
3. Press the
DISP
button to display the Waveform Screen. The
data specified by step 2 is displayed.
Waveform Screen
1. Press the
DISP
button to display the Waveform Screen.
2. Press a Channel Select button (CH1 to CH4) to display the
block allocation status.
The blocks shown by
indicate that measured data has
been saved to the blocks.
3. Move the flashing cursor to position 1 and specify the
block to be displayed, or use the Cursor buttons to specify
the block 2 and press the
buttons to display the
waveform in the specified block.
To Next Page
Loading...
