11.2 Importing Data to a Computer
209
Chapter 11 Connection to a PC
11
Computer Requirements: A personal computer running Windows 7, Windows 8,
Windows 10.
To exit USB Drive Mode
Connecting the Instrument and Computer
• Do not eject the CF card or pull out the USB cable during data trans-
fer. Doing so would prevent proper data transfer.
• The Memory HiCorder and computer should be connected to the
same earth ground. If grounded separately, potential difference
between the ground points can cause malfunctions or damage when
connecting the USB cable.
Before connecting the USB cable to the HiCorder, select the USB Drive
Mode on the [System] screen. If you connect the USB cable without
setting USB Drive Mode, the data on the CF card or USB flash drive of
the instrument are not able to be accessed.
Connect one end of the USB
cable to the USB port on the
instrument while making sure
the plug is oriented correctly.
1
Connect the other end of the cable
to a USB port on the computer.
The computer should recognize the Mem-
ory HiCorder as a removable disk when
the cable is connected.
2
Removable
Disk
1 Click the Safely Remove Hardware ( )
icon in the Windows
®
notification area.
2 Click the appropriate line "Safely remove
USB Mass Storage Device – Drive(H:)"
where H is the drive letter that Windows
assigned to the HiCorder.
3 When "Safe to remove hardware" appears,
click [X] or [OK].
4 Disconnect the USB cable.
To Next Page
Loading...
Need help?
General
