Lithium Battery
Lead
Circuit board
8 Remove the screws (2) securing the circuit
board and the hexagonal standoffs (5).
9 Remove the circuit board to which the lithium
battery (back surface) is attached.
10 Lift up the lithium battery on the circuit board,
and then cut both the + and - leads with a pair
of wire cutters.
10
8
CALIFORNIA, USA ONLY
This product contains a CR Coin Lithium Battery which contains Perchlo-
rate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
To Next Page
Loading...
