Hioki MEMORY HiCORDER MR8880 User Manual

Appendix 1 Error Messages and Remedial Actions
A4
402
Cannot load this file.
The format of the file is incompatible with the HiCord-
er, or the file is corrupt. Refer to "6.1 Saving & Load-
ing Data" (p. 147) for loadable file formats.
403
Insert a Media.
A CF card or USB flash drive is not present. Insert
storage media.
404
Directory full.
1. Reduce the number of files by moving files in the
directory to other storage media.
2. If you set [Deleting] to [On] when using automatic
saving, the most recent file will be saved normally
when the directory becomes full because the old
-
est file will be deleted.
405
Not enough capacity.
The removal storage as insufficient space to save
the file. Delete files to increase free space, or re-
place the removal storage.
406
Process interrupted (not enough
battery capacity).
The file cannot be processed because there is insuf-
ficient battery power. Charge the battery or connect
the AC adapter.
407
Insert CF card or USB memory.
A CF card or USB flash drive is not present. Insert
storage media.
408
Preparing to protect file. Do not
access the storage media for
about 3 minutes after turning on
the device.
Allow about three minutes for the capacitor to
charge.
410
This file may be corrupted.
Check or perform the following:
1. Verify that the CF card is specified by Hioki (p. 46)
2. Reformat the CF card (p. 48)
If the message persists after performing the above,
either the CF card or Memory HiCorder may be dam-
aged. Contact your dealer or Hioki representative.
430
Unsaved data present.
The cause is likely to be that a CF card or USB flash
drive is not inserted or there is insufficient free
space. Insert a CF card or USB flash drive, and then
manually save any necessary data.
431
Insert media to save waveform da-
ta.
Insert a removal storage.
432
Change media.
Removable storage cannot be accessed. Replace
the CF card or USB flash drive.
434
Media is full or cannot delete old-
est wave file.
This may appear while measuring using waveform
auto save.
A file could not be saved: Not enough space on the
removable storage.
435
Media is nearly full.
Not enough space on the removal storage. Replace
with a new removal storage.
436
Saving interrupted (Low battery).
Battery charge is too low to save. Recharge, or con-
nect the AC adapter.
Message Remedial Action

Hioki MEMORY HiCORDER MR8880 Specifications

General

Brand	Hioki
Model	MEMORY HiCORDER MR8880
Category	Voice Recorder
Language	English