Contents
ii
USB Flash Drive Insertion & Removal ..................................... 47
Formatting a CF Card/USB Flash Drive .................................. 48
2.8 Compensating for Input Circuit Offset
(Zero Adjustment) ................................................... 49
Chapter 3
Basic Operating Procedures _______________ 51
3.1 Pre-Operation Inspection....................................... 51
3.2 Measurement Flow ................................................. 52
3.3 Basic Operation ...................................................... 55
Checking Input State (Monitor) ................................................ 55
Configuring Settings (Changing Settings) ................................ 57
Starting and Stopping Measurement ....................................... 58
Viewing Measurement Results (Scrolling Waveforms
& Displaying Measurement Values) ......................................... 60
Saving Data ............................................................................. 61
Printing Data ............................................................................ 62
Disabling Key Operations (Key-Lock Function) ....................... 62
3.4 Measurement Using Setting Wizard
(PRESETS key) ........................................................ 63
Configuring Settings by Following Instructions in Navigation
(Basic Guide) .......................................................................... 63
Selecting Application and Configure Settings
(Measurement Guide) .............................................................. 64
Loading Setting Configuration Data ......................................... 65
Chapter 4
Setting the Measurement Conditions
(When you want to customize the settings)67
4.1 Flow of Configuring Settings Individually ............ 67
4.2 Recording Methods (Measurement Functions) ... 68
4.3 Using High-speed Function
(Instantaneous Recording) .................................... 70
Selecting the Function (High-speed Function) ........................ 70
Setting the Horizontal Axis (Time Base Range) ...................... 71
Setting Recording Length (no. of divisions) ............................. 74
Set the Recording Length for Repeated or One-time Recording . 75
Configuring Settings Automatically (Auto Range) .................... 76
To Next Page
Loading...
