4.3 Changing Recording (Save) Settings
72
Waveform save
Sets whether to save waveform data for each time interval as a binary-format file.
The minimum time interval is 1 minute. When the parameter is set to less than 1
minute, waveforms are saved every minute. Waveforms are not saved in the instru-
ment’s internal memory. To save waveforms, set the save destination to [SD card].
Folder/File name
Sets the filename used to save data.
See: 8.2, "Folder and File Structure" (p. 116)
Selection
ON
The waveforms will be saved.
OFF
The waveforms will not be saved.
Selection
MANUAL
Allows the user to set a folder name with a dialog box (up
to five byte characters). When measurement is repeated
without changing the folder name, a number will be auto-
matically appended to the folder and file name. (Folder/
filename + folder sequential number [2 digits])
AUTO
Automatically appends a number in the format “YYMMD-
DXX.” The first six characters consist of the date, and
subsequent numbers consist of a sequential number.
The maximum file size for measurement data is 200 MB approxi-
mately. When this size is exceeded, a separate file will be created
in wh
ich to save the data. (Folder/filename + folder sequential
number [2 digits] + file sequential number [2 digits])
To Next Page
Loading...
