EasyManua.ls Logo

Hioki PW3390 - 10.4 Setting Specifications

Hioki PW3390
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10.2 Basic Specifications
196
(3) Pulse Input (CH B only)
Detection level Low: 0.5 V or less, High: 2.0 V or more
Measurement range 1 Hz to 200 kHz (at 50% duty)
Division setting range 1 to 60000
Measurement frequency range 0.5 Hz to 5.0 kHz (limited to measured pulse frequency divided by selected no. of divisions)
Minimum detectable pulse width 2.5 µs or better
Measurement accuracy ±0.05% rdg. ±3 dgt.
(4) Pulse Input (CH Z only)
Detection level Low: 0.5 V or less, High: 2.0 V or more
Measurement range 0.1 Hz to 200 kHz (at 50% duty)
Minimum detectable pulse width 2.5 s or better
Settings OFF/Z Phase/B Phase (clear counts of CHB in rising edge during Z Phase, detect polar code for
number of rotations during B Phase)
7. D/A Output Option Specifications (Models PW3390-02 and PW3390-03)
Number of output channels 16 channels
Output contents Selectable waveform/analog outputs (from basic measurement parameters)
Waveform output only on Channels 1 to 8
Output connector One 25-pin female D-sub
D/A conversion resolution 16 bits (polarity + 15 bits)
Output accuracy Analog output: Measurement accuracy ±0.2% f.s. (DC level)
Waveform output: Measurement accuracy ±0.5% f.s. (at ±2 V f.s.), ±1.0% f.s. (at ±1 V f.s.)
(rms level within synchronous frequency range)
Output update interval Analog output: 50 ms (according to input data update interval of selected parameter)
Waveform output: 500 kHz
Output voltage Analog output: ±5 V DC nom. (approx. ±12 V DC max.)
Waveform output: ±2 V/±1 V switchable, crest factor of 2.5 or greater
Setting applies to all channels.
Output impedance 100 ±5
Period of guaranteed accuracy 6 months (For 1 year accuracy, calculate the specified accuracy for 6 months ×1.25)
Conditions of guaranteed accura-
cy
Temperature and humidity: 23°C±3°C (73°F±5°F), 80% RH or less
Warm-up time: 30 minutes or more, After zero adjustment of the PW3390
Temperature coefficient ±0.05% f.s./°C
Pinout
13 12 11 10 9 8 7 6 5 4 3 2 1
25 24 23 22 21 20 19 18 17 16 15 14
Pin No. Output (Waveform) Pin No. Output
1GND14GND
2 D/A1 (U1) 15 D/A9
3 D/A2 (I1) 16 D/A10
4 D/A3 (U2) 17 D/A11
5 D/A4 (I2) 18 D/A12
6 D/A5 (U3) 19 D/A13
7 D/A6 (I3) 20 D/A14
8 D/A7 (U4) 21 D/A15
9 D/A8 (I4) 22 D/A16
10 GND 23 GND
11 GND 24 GND
12 GND 25 GND
13 GND


Table of Contents

Other manuals for Hioki PW3390

Related product manuals