4.5 Viewing Waveforms
80
Displaying Separate Channel Waveforms
Select [CH]
(Separate Channel)
Voltage Scale
(Positive-only display)
Current Scale
(Negative-only display)
RMS (rms)
Waveform Display En-
able/Disable (p. 81)
Negative Peak
Value (pk-)
Positive Peak
Value (pk+)
Waveform color ap-
pears when enabled
(ON).
• Waveforms and numerical measurement values displayed at the right are not synchronized
with measurement timing.
• Displayed waveform values are not the calculated RMS and peak numerical values.
• The vertical axis of the waveform is displayed as a percentage of the full-scale range of each
channel, so the amplitudes of different channels are not directly comparable.
• To display waveforms starting from zero amplitude, see "Zero-Crossing Filter Setting Proce-
dure" (p. 57).
• Pressing the HOLD key will trigger the HOLD state. However, display data updates will not
function for the waveform display. See "5.3.1 Data Hold Function" (p. 112).
To Next Page
Loading...
