Hirschmann RS20 User Manual

Entering the IP Parameters
42
2.5 System configuration via BOOTP
Basic Configuration
Release 6.0 07/2010
switch_01:ht=ethernet:ha=008063086501:ip=10.1.112.83:tc=.global:
switch_02:ht=ethernet:ha=008063086502:ip=10.1.112.84:tc=.global:
.
.
Lines that start with a ‘#’ character are comment lines.
The lines under “.global:” make the configuration of several devices easier.
With the template (tc) you allocate the global configuration data (tc=.global:)
to each device .
The direct allocation of hardware address and IP address is performed in the
device lines (switch-0...).
 Enter one line for each device.
 After ha= enter the hardware address of the device.
 After ip= enter the IP address of the device.
In the appendix under “Setting up a DHCP/BOOTP Server“ on page 218, you
will find an example for the configuration of a BOOTP/DHCP server.

Hirschmann RS20 Specifications

General

Mounting	DIN Rail
Operating Temperature	-40°C to +70°C
Protection Class	IP30
Switching Technology	Store-and-Forward
Product Type	Industrial Ethernet Switch
Port Details	10/100 Mbps Ethernet ports
Switching Capacity	3.2 Gbps
MAC Address Table	8k
Management	Web, SNMP
Redundancy	MRP
Ports	8 or 16