Entering the IP Parameters
Basic Configuration
Release
6.0
07/2010
2.5
System configuration via BOOTP
45
Note: The loading process started by DHCP/BOOTP (see on page 218
“Setting up a DHCP/BOOTP Server“) shows the selection of "from URL &
save locally" in the "Load" frame. If you get an error message when saving a
configuration, this could be due to an active loading process. DHCP/BOOTP
only finishes a loading process when a valid configuration has been loaded.
If DHCP/BOOTP does not find a valid configuration, then finish the loading
process by loading the local configuration in the "Load" frame.
To Next Page
Loading...
