WARNING
:
Use a cleaning solvent which is designed to
clean parts only. Never use gasoline or low
flash point solvents as they may cause a
fire or explosion.
b. squeeze the excess solvent out of the element
and let it dry.
NOTE:
Do not twist or wring out the element. This could
damage the foam material.
c. Squeeze out the excess oil.
NOTE:
The element should be wet but not dripping.
4. Install:
·air filter element
·air filter case cover
NOTE:
To prevent air leaks make sure that the sealing
surface of the element matches the sealing
surface of the case.
CHECKING THE COOLANT LEVEL
1. Place the vehicle on a level surface.
2. Remove front faceplate
3. Check:
·start the engine, warm it up for several minutes,
and then turn it off.
·coolant level
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
To Next Page
Loading...
