Hisun HS200UTV - Checking the V-Belt

-98-
MAINTENCE AND ADJUSTMENT OF THE UTV
- 98 -
.
The coolant signal light contains 6 segments. The
first segment means 60℃ ， the second means
70 ,the third means 80 ,the forth means ℃℃
90 ,the fifth means 100 and sixth means ℃℃
110 .If the sixth segment is light ,the cooling ℃
system would be examined because the
temperature of water is too high.
CHECKING THE V-BELT
1. Remove:
·
driver seat
·
passenger seat
·engine cover board
·fuel tank
·drive belt cover
·Check:
a. V-belt ①
Cracks/wear/scaling/chipping
Replace.
Oil/ grease
Check primary sheave and
secondary sheave。
b. V-belt width ②
Out of specification
Replace.
.
Coolant temperature warning light checking method
MAINTENCE AND ADJUSTMENT OF THE UTV
- 99 -
·
Replace V-belt:
Install the bolts ① into the secondary fixed
sheave hold.
NOTE:
Tightening the bolts ①will push the secondary
sliding sheave away, causing the gap between
the secondary fixed and sliding sheaves to
widen.
·Remove the V-belt ①from the primary sheave
and secondary sheave.
·Install the V-belt.
NOTE:
Install the V-belt so that its arrow faces the
direction shown in the illustration.
· Remove the bolts.
2. Install:
· drive belt cover
· driver seat
CLEANING THE SPARK ARRESTER
1. Clean:
Tap the tailpipe lightly with a soft-face hammer or
suitable tool, then use a wire brush to remove any
carbon deposits from the spark arrester portion of
the tailpipe and the inner contact surfaces of the
muffler
2. Spark arrester
V-belt width: 23.6 mm
<Limit:> 21. mm
.