Inspect fastens nut of the steering wheel whether
does have flaw and fissure , if it is, must replace.
Check the internal spline between the steering
wheel and steering column whether have
damaged, if the attrition is serious, must replace
the steering wheel.
CHECKING AND SERVICE THE STEERING
COLUMN PARTS
1. Check:
• steering column tube ①
• bearing ②
• central axis of the steering shaft ③
• spline ④
• loosening ⑤
The central axis of the steering shaft whether
flexible and moves. If does, dismantle and check
the axis, bearing and retaining ring whether ware
or damaged, according to the inspection situation
to instead the parts.
2. Check:
The two ends of the spline on the central axis
whether is wear out, if so, instead the central
axis.
3. Check:
The spline in the two ends of the central axis
whether have wear, if dose, instead the central
axis.
4. Check:
The steering shaft tube and welding line of the
branch whether have crack and corrosion, if it
does, instead the steering shaft tube.
DIASSEMBLING THE STEERING DRIVE AXLE
1. Loose the clamp one piece M8×30 flange bolt
in the cross gimbal, internal spline on the top of
the steering drive axle, pull out the top of the
steering drive axle.
2. Loose the clamp one piece M8×30 flange bolt in
the cross gimbal, spline on the bottom of the
steering drive axle, pull out the lower of the
steering drive axle.
To Next Page
Loading...
