Hitachi Compute Blade 500 Series - LPAR Manager Cooperation Function

Item Operation
BMC Creating CSR Resources
tab > Modules > All modules >
Server Blade > Server Blade x > BMC tab > Edit
> Edit certificate
Importing
certificate
Resources tab > Modules > All modules >
Server Blade > Server Blade x > BMC tab > Edit
> Edit certificate
LPAR manager cooperation function
This topic describes the procedures enabling LPAR manager usage. The
following procedure sets the parameters for LPAR manager installation,
configuration, and operation.
Confirm the following settings before operating the functions explained in this
section.
•
Setting an IP address to a server blade
• Cable connecting to the System unit
• Setting the EFI
For the settings above, see the Hitachi Compute Blade 500 Series Server
Blade Setup Guide.
For the functional list of Web console and HVM Navigator, see the following
table.
Perform the functions which are not supported on Web console on HVM
Navigator.
Table 2-100 Functional List of Web console and HVM Navigator
Function Web console
HVM Navigator
V02-04 or later
Initializing LPAR manager Y -
Synchronizing LPAR manager System
Time with NTP server
- Y
Selecting LPAR manager firmware Y -
Confirming virtual WWN
Y
1
Y
Confirming virtual MAC address Y Y
Turning on server blade
Y
1
-
Configuring LPAR
Y
2
Y
Adding LPAR
Y
2
Y
Setting number of processors assigned to
LPAR
Y
2
Y
2-110
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide