Hitachi Compute Blade 500 Series - Reactivating LPAR

Tip: When the management module firmware version is A0125 or earlier,
Start R-KVM console is
displayed.
5. Click OK.
Then the remote console window will be displayed.
Reactivating LPAR
Perform the following procedure for reactivating LPAR. When an LPAR is
reactivated, a guest OS operating on the LPAR is rebooted forcibly. So, be
sure to confirm the state of the guest OS before reactivating an LPAR. On the
other hand, when a guest OS is rebooted properly, execute the operation for
reboot on the guest OS.
1. Click Resources.
Functional detail
2-167
Hitachi Compute Blade 500 Series Management Module Setup Guide