Hitachi Compute Blade 500 Series - Management Module Setting

Item Available operation
LPAR manager settings Backing up and restoring
Management module setting
This subsection describes backing up and restoring settings for management
modules.
Backing up
The backing up the management module settings is available from the
management module console. It takes about several minutes.
Note:
•
In the non-redundant management module configuration, back up the
management module and reposit it. When replacing the management
module, restoring the setting is not available if the backup file does not
exist.
• If settings are changed from the console or if power status of the server
blade changes while settings are being backed up, the backup may fail.
Perform backup operation in the state that those potential failures are
prevented.
Table 2-165 Web console operation
Item Operation
Backing up management
module setting
Resources
> Modules > All modules > Management
modules > Action > Backup Settings
Restoring
The restoring the management module settings are available from the
management module console. It takes about several minutes and the
management module reboots after completing the restoration.
Note:
•
When restoring the management module settings, the management
module reboots after completing the restoration and stops the operation.
Do not restore the settings during the management module is in
operation.
• When restoring the management module settings, the LPAR manager
settings are also restored to the backed up settings.
• When backed up settings are restored to a management module with the
firmware version later than that of the backed up settings, functions not
supported at the backup are set as default.
Functional detail
2-301
Hitachi Compute Blade 500 Series Management Module Setup Guide