Hitachi Compute Blade 500 Series - Testing E-Mail Configuration (by Sending Current Status)

Testing E-mail configuration (by sending current status)
After setting parameter setting for E-mail, perform notification test using
notification of current status. You can select the destination E-mail address
from the address list which you set. It is possible to specify one designation
address or all of the address.
Table 2-132 Web console operation
Item Operation
Notification of current status (by
manual operation)
Administration tab > E-Mail Notification
> Action
button > Present condition notification
Table 2-133 CLI console command
Item Command
Notification of current status (by manual operation) send e-mail latest mgmt-lan
Tip:
•
It takes several minutes to collect log information.
• The notification by E-mail function is assumed as normal end when the
notification is sent to the SMTP server correctly.
• When you send the notification to multiple destinations, a failure to one
destination may cause the failure to all of the destinations.
• When a mailing fails, confirm the environment and settings based on the
result message and following description.
- Confirm whether the communication between the management module
and SMTP server is available.
When the communication is unable:
Confirm whether the LAN cable is connected correctly.
Confirm the network setting for management module.
When designate the SMTP server with the host name, designate the DNS
in the network setting for management module.
- Confirm whether the SMTP service is active on the SMTP server.
When the service is not active, start the SMTP service.
- Confirm whether the basic information for notification by E-mail and the
setting of destination address information are correct.
The following table shows the messages for the notification of current status.
Table 2-134 Messages for notification of current status
Code Message Description Action
E0410 <Address %> Sending e-
mail notification was
canceled. Address is not set.
Destination address is
incorrect or user does not
exist corresponding to
the destination address.
Confirm the E-mail
settings especially the
destination address.
Functional detail
2-243
Hitachi Compute Blade 500 Series Management Module Setup Guide