Downloading dump logs
The following provides how to download dump logs on the management
module Web console.
•
Click Dashboard tab > Dump Log button in System Event Log pane in
the lower right.
• Click a tab other than Dashboard > Dump Log button under General
Tasks on the lower left on the window.
Logs are saved on the PC connected to the Web console. Follow instructions
shown on the window to specify a location to save logs.
Note: Disable the pop-up blocker in Internet Option settings for the Web
browser. A pop-up message appears when dump logs are downloaded. If with
pop-up blocker enabled, no pop-up message appears and dump log download
fails.
Operation log and audit log
The operation log or audit log records the operation history of system unit. It
records the management module operation and server operation described in
Operation log and audit log messages on page 2-270.
Note:
•
When using redundant. Management modules configuration, the operation
log or audit log is lost after replacing an active management module.
• When replacing server blade, the operation log or audit log is lost after
replacing the server blade.
• The operation log or audit log format may differ depending on the
firmware version.
The following table shows the specification of the operation log and audit log.
Table 2-144 Specification of the operation log and audit log
Item
Server blade operation log
and audit log
Management module operation log
and audit log
Recording
category
Recording success, fail, occurrence for each operation event category
Recording
operation
Recording start, stop, authentication, setting change, and maintenance.
For more detail about recording operation, see Operation log and audit
log messages on page 2-270.
Recording
number of
event
2048/server blade Operation with server blade privilege:
2048/server blade
Others: 2048/chassis
When the each number exceeds the maximum number of events, the
oldest event is overwritten.
Down loading • Download from the management module Web console.
Functional detail
2-265
Hitachi Compute Blade 500 Series Management Module Setup Guide
To Next Page
Loading...
