Hitachi Compute Blade 500 Series Management Module Setup Guide

Table 2-168 Web console operation
Item Operation
Backing up LPAR manager
configuration information
Resources
> Modules > All modules > Server Blades
> target Server Blades > Action > Backup LPAR
manager settings
Restoring
LPAR manager configuration information can be restored by operating any of
the consoles for the management module. It takes several minutes.
When LPAR manager configuration information is restored, use a backup file
fulfilling the following requirements.
•
Backup file of a restored LPAR manager
• File backed up when an LPAR manager firmware version which is assigned
to a server blade now was assigned to the same server blade
If a backup file does not fulfill the requirements above, an LPAR manager
would not operate properly after restoring.
Note: When a server blade is turned off, LPAR manager configuration
information can be restored.
Table 2-169 Web console operation
Item Operation
Restoring LPAR manager
configuration information
Resources > Modules > All modules > Server Blades >
target Server Blades > Action > Restore LPAR
manager settings
CBTP
Overview
CBTP. Compute Blade Test Program, is a test program to run after hardware
is changed for maintenance. Maintenance personnel execute CBTP after
changing hardware. You need to execute it as well if changing hardware for
maintenance by yourself. The following CBTP feature can be executed from a
management module:
Starting CBTP using the ISO image contained in the flash memory embedded
in the server chassis
For details about CBTP, see the Hitachi Compute Blade 500 Series System
Service Manual. When you want to change the hardware for maintenance,
see the Hitachi Compute Blade 500 Series System Service Manual.
Functional detail
2-303
Hitachi Compute Blade 500 Series Management Module Setup Guide

Hitachi Compute Blade 500 Series Specifications

General

Brand	Hitachi
Model	Compute Blade 500 Series
Category	Server
Language	English