Hitachi Compute Blade 500 Series - Collecting LP Dump Logs with LPAR Manager in Operation

Collecting LP dump logs with LPAR manager in operation
This subsection describes how to collect LP dump logs with LPAR manager in
operation. LP dump logs collected by this procedure are used for failure
analysis. LP dump log collection is not required in daily operation. You may be
asked to collect LP dump logs when the system unit does not work properly.
[Management module firmware version A0145 or later]
1. Click Resources
tab.
2. Click Modules
> All Modules > Server blades, and select a server
blade.
2-210
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide