Hitachi Compute Blade 500 Series - Setting Connection Procedure

through management module console" or "Connect through management
LAN port" and set the IP address to the external port directly from the
switch module console.
•
When using the change console command for CLI console with the
Brocade 10 Gb/sec DCB switch module or Brocade 16 Gb/sec Fibre
Channel switch module, set an IP address other than 0.0.0.0 for the
switch module.
• After "Connect through management module console" is selected on the
management module CLI console with Brocade 10 Gb/sec DCB switch
module, "Connect through management LAN port" is shown on the
management module Web console. Then, if you save the setting without
changing on the Web console, "Connect through management LAN port"
is set.
Table 2-21 Web console operation
Item Operation
Displaying/setting connecting switch
modules to management interface
Resources tab > Systems > Network >
Management LAN
Setting connection procedure
The management interface of each module can be connected from MGMT0 or
MGMT1.
Select one of the following connection procedures. You can change the
procedure for each module.
•
Connecting from MGMT0:
• The factory default setting.
• Connecting from MGMT1:
For details, see
Connecting management interface from MGMT1 on page
2-16.
•
Connection with Tag-VLAN (MGMT0/MGMT1):
For details, see
Connecting with Tag-VLAN to management interface on
page 2-17.
Note: Do not assign the management interface of switch module to the
internal network. When assign to the internal network, the management
interface may not be connected from both MGMT0 and MGMT1.
The following tables describe the factory default network settings.
Table 2-22 Factory default setting for network
Module Default setting Note
Management
module
Connection from
MGMT0
-
Functional detail
2-15
Hitachi Compute Blade 500 Series Management Module Setup Guide