Hitachi Compute Blade 500 Series - Remote Control for Server Blade; Using Remote Console

• Power on
•
Power off
• Recovering the status before failure occurred.
The above operations can recover the power supply automatically for the
server blade.
You can set the waiting time from booting the system unit to turning on the
server blade. The waiting time can be set between 0 minute and 60 minutes.
This configuration can turn on the server blade until peripheral devices turned
on completely when peripheral devices need to be turn on before turning on
the server blade.
Note:
•
For the standby server blade of N+M cold standby function, you should
set "turn off" on this configuration. If the standby server blade is set "turn
on", the standby server blade cannot be performed N+M cold standby
failover.
• When N+M cold standby function is enabled, you must set this function
for server blade operation setting of recovering power failure. If you set
this function using UEFI setup menu, the server blade may not be
operated this function correctly.
Tip: In SMP configuration, each server blade operates with the primary
server blade settings. You need not to perform setting for non-primary server
blades.
Table 2-53 Web console operation
Item Operation
Displaying the server blade operation
setting when power failure recovery
Resources
tab > Modules > All modules >
Server Blade > Server Blade x > Settings
Tab
Note:
*x: One of Server blade 0 – 7
Remote control for server blade
This section describes controlling a server blade with remote console or OS
console.
Using remote console
This system unit uses remote consoles as graphical console of each server
blade. You can operate by remote control for displaying VGA, operating
keyboard/mouse, remoting CD/DVD, and remoting FD. For details about
operating the remote console, see the Hitachi Compute Blade 500 Series
Remote console user guide.
2-44
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide