Hitachi Compute Blade 500 Series - Link Fault Tolerance (LFT)

Address type Address assignment
IPv6 stateless address Based on the prefix distributed by the router and the
interface ID (MAC address), an IPv6 address is
automatically generated and assigned.
This address is different from that of the previous main
management module.
Tip: The LAN cable needs to be connected to both of the main and standby
management module for continuing operation after switching the
management module.
Figure 2-6 System unit configurations for network re-configuration
Link Fault Tolerance (LFT)
The management network can be configured with redundancy when installing
two management modules in the system unit. This function is referred to as
"Link Fault Tolerance (LFT)".
Functional detail
2-25
Hitachi Compute Blade 500 Series Management Module Setup Guide