Hitachi Compute Blade 500 Series Management Module Setup Guide

ID
Operation
category
Recording trigger Message
1008 Login to server blade
Web console
Logged in to the server blade web
console. Username:xxx Source IP
address:xxx User authentication
method:xxx
1009 Logout from server
blade Web console
Logged out from the server blade
web console. Username:xxx Source
IP address:xxx Cause:xxx
100A Failing login to server
blade Web console
Failed to login to the server blade
web console. Username:xxx Source
IP address:xxx Cause:xxx
Firmware
This section describes updating firmware for management modules and
server blades.
Updating firmware from the management module
Firmware is software embedded in a device to provide basic control over
hardware. Multiple pieces of firmware are embedded in the system unit. You
can update the following firmware using the management module.
Table 2-150 Firmware type
Name Description
Management module firmware Runs on a management module.
Dictionary Is a data file installed on a management module;
converts log messages.
1
Device parameter Is a data file installed on a management module;
includes parameters for modules installed in the system
unit.
1
Server blade firmware Runs on a server blade; includes BMC and UEFI.
LPAR manager firmware Runs LPAR manager on a server blade.
For details about how to update the LPAR manager
firmware, see
Updating LPAR manager firmware on page
2-196.
Note:
1. This is not firmware in a strict sense, but is updated from a management module
like firmware. That is why it is included in this table.
2-280
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide

Hitachi Compute Blade 500 Series Specifications

General

Brand	Hitachi
Model	Compute Blade 500 Series
Category	Server
Language	English