Hitachi Compute Blade 500 Series - DCMI Commands

Table 2-115 CLI console command
Item Command
Switching to the DCMI mode set power dcmi-mode
2. Confirm that blade initialization is complete.
If server blades that support DCMI are re-initialized when you change to
the DCMI mode, check the system event log to confirm that the
initialization of the target server blades is complete.
To confirm that initialization is complete from the Web console, in the
[Resources] tab, from the [Modules] tree, select [Server Blades] and then
a target server blade. Then, in the [Condition] tab of the server blade,
confirm that [Initialization status] is [OK].
Note:
•
Do not switch to the DCMI mode while updating the integrated firmware
of server blades that support DCMI.
• Before switching to the DCMI mode, confirm that the integrated firmware
is not being updated on any server blade that supports DCMI.
• If you updated the integrated firmware, check the system event log to
confirm that initialization of the target server blades is complete.
• To confirm that initialization is complete from the Web console, in the
[Resources] tab, from the [Modules] tree, select [Server Blades] and then
a target server blade. Then, in the [Condition] tab of the server blade,
confirm that [Initialization status] is [OK].
• To downgrade the management module firmware that supports DCMI to
firmware that does not support DCMI, disable the DCMI mode in advance.
If you downgrade the firmware while the DCMI mode is enabled, the APC
functionality might not operate correctly.
DCMI commands
See the following table for details about the commands that are defined in
DCMI version 1.5 and supported in CB 500.
Table 2-116 DCMI commands
DCMI command NetFn CMD
Min Privilege
level
Support of
CB 500
Get DCMI Capabilities Info DCGRP (2Ch, 2Dh) 01h Session-less Y
Set DCMI Configuration
Parameters
DCGRP (2Ch, 2Dh) 12h Admin Y
Get DCMI Configuration
Parameters
DCGRP (2Ch, 2Dh) 13h User Y
Get Management Controller
Identifier String
DCGRP (2Ch, 2Dh) 09h User Y
Functional detail
2-229
Hitachi Compute Blade 500 Series Management Module Setup Guide