Hitachi Compute Blade 500 Series Management Module Setup Guide

Table 2-129 Attached file specification
File name Content
Maximum size
Upper row:
Automatic
notification
Bottom row: Manual
notification
svpsts-YYYYMMDD-
hhmmss.gz
System unit information 500 KB
500 KB
trc-YYYYMMDD-
hhmmss.tar.gz
Management module log information 1000 KB
1500 KB
hvmdumpN-YYYYMMDD-
hhmmss.gz
Sever blade log information
(related to LPAR manager)
3000 KB
not attached
raslogN-YYYYMMDD-
hhmmss.tar.gz
Sever blade log information
(related to hardware)
2000 KB
not attached
marlog.gz Failure information
(same information included the
notification of failure)
1 KB
not attached
Setting notification by E-mail
When you use the notification by E-mail
function on the management
module, you need to set notification information and destination address. The
notification information is set to management module and SMTP server. The
destination address is the E-mail address to which the notification is sent. For
details about setting items, see the Hitachi Compute Blade 500 Series Web
Console User's Guide.
Setting notification information
Set the following items for e-mail notification information.
• Notification parameter
Six setting items for sending e-mail are shown below.
¢
Enabling/disabling function for notification by E-mail
¢
Sender E-mail address
¢
Host name
¢
Comment
¢
SMTP server
¢
Port number
Note:
Functional detail
2-241
Hitachi Compute Blade 500 Series Management Module Setup Guide

Hitachi Compute Blade 500 Series Specifications

General

Brand	Hitachi
Model	Compute Blade 500 Series
Category	Server
Language	English