Hitachi Compute Blade 500 Series - Backing up and Restoring Settings; Possible to Save and Restore Configuration

(4) Checking the new version
This subsection describes how to check that the latest version, which was
obtained in (1) Obtaining the latest version of Server blade firmware on page
2-294, has been properly applied.
1. Click Resources
tab > Systems > Firmware.
2. Total version on Server Blade tab shows the current firmware version.
Check that all updated server blades show the latest updated firmware
version.
Backing up and restoring settings
This section describes backing up and restoring settings executed by
management modules.
Possible to save and restore configuration
The following backing up and restoring settings are available from the
management module.
Table 2-164 Backing up and restoring setting
Item Available operation
Management module settings Backing up and restoring
Fibre Channel mezzanine card settings Backing up
2-300
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide