Hitachi Compute Blade 500 Series - Banner Feature; Login Banner Feature

Table 2-135 Web console operation
Item Operation
Displaying/Setting Syslog transfer
for management modules
Administration tab > Syslog transfer
Displaying/Setting Syslog transfer
for BMC
Resources tab > Modules > All Modules >
Server Blades
> Server Blade x > BMC tab
Note:
•
Only one syslog server can be specified as destination.
• Syslog transfer does not support SSL3.0.
(3) Sending Syslog transfer test message
When you log into the management module CLI console or Web console,
"Logged in to the System Console" or "Logged in to the System Web Console"
is sent. For BMC, "Logged in to the remote console" is sent when you log into
BMC. Check if the message is sent or not. When the message is sent, Syslog
transfer setting is correct.
Banner feature
Login banner feature
This section describes the login banner feature of the CB 500 management
module.
Overview of the login banner feature
The login banner feature displays a login banner (warning) when the
management module is connected. Whether the login banner is displayed
depends on the access method, as follows.
Table 2-136 Whether the login banner is displayed
# Access method Banner display
1 CLI console Displayed
2 Web console Displayed
3 LCD touch panel Not displayed
Display example for the CLI console:
Preset banner text is displayed before the login prompt (login:) as shown.
Functional detail
2-247
Hitachi Compute Blade 500 Series Management Module Setup Guide