Hitachi Compute Blade 500 Series - MegaRAID WebBIOS for storage expansion blades

Restoring LPAR manager configuration information
Perform the following procedure for restoring LPAR manager configuration
information. When LPAR manager configuration information is restored, use a
backup file fulfilling the following requirements.
•
Backup file of a restored LPAR manager
• File backed up when an LPAR manager firmware version which is assigned
to a server blade now was assigned to the same server blade
If a backup file does not fulfill the requirements above, an LPAR manager
would not operate properly after restoring.
Tip: In SMP configuration, select the primary server blade to restore LPAR
manager configuration information.
Restore LPAR manager configuration information following the steps below.
You can restore the configuration when the server blade is powered off.
1. Click Resources.
2. Click Modules
> Right pointing triangle to All Modules then Server
Blades > target server blade.
Functional detail
2-187
Hitachi Compute Blade 500 Series Management Module Setup Guide