Hitachi Compute Blade 500 Series Management Module Setup Guide

Notification of history log (triggered by manual operation)
You can resend one of the history log stored at the failure occurrence.
For example, when the notification of failure occurrence is failed due to the
mail server is in stop status, it is possible to send the E-mail after the mail
server recovery.
Tip: When you perform the log dump from the server blade, the notification
of log dump above occurs. However, an E-mail regarding to the notification of
failure is not created.
Requirement
• A mail server (SMTP server) is required. The notification by E-mail is a
function that the management module as a mail client sends an E-mail to
a mail sever (SMTP server).
• The management must be in an environment that can communicate with
a mail server.
Notification by E-mail specification
The following table shows the specification of the function.
Table 2-128 Specification of function
Item Specification
Notification method E-mail (SMTP compliance)
Maximum number of destination address 4
Maximum number of SMTP server 1
Notification trigger • Failure occurrence
•
Log output from server blade
• Operation by manual
(Notification of current status,
Notification of history log)
Notification retry Communication failure during:
• Notification of failure
• Notification of log output
Mail
content
Notification of failure Subject [AUTO] Failure report
Body • Mail description: The trouble
occurred by the following device.
• Server chassis information
• Failure information (Abstract)
Attached file
1
• svpsts-YYYYMMDD-hhmmss.gz
•
trc-YYYYMMDD-hhmmss.tar.gz
2
• marlog.gz
Functional detail
2-239
Hitachi Compute Blade 500 Series Management Module Setup Guide

Hitachi Compute Blade 500 Series Specifications

General

Brand	Hitachi
Model	Compute Blade 500 Series
Category	Server
Language	English