Hitachi Compute Blade 500 Series - Page 266

• The management module does not support the email notification
function that uses IPv6 stateless addresses.
To communicate with the SNMP server by using IPv6 addresses,
disable the stateless address setting of the management module.
• SMTP authentication parameter
Three items of SMTP server authentication are shown below.
¢
Enabling/disabling SMTP authentication
¢
Account
¢
Authentication method
•
Encryption parameter
The following item is for setting encryption parameter.
Encryption for SMTP path
Note: When Security strength is set to high for the management module,
configure TLS for the encryption version for e-mail notification route, and
CRAM-MD5 for SMTP authentication method. If not configured, e-mail is not
sent.
Setting destination address information
Set the following items for e-mail notification destination.
•
Destination address parameter
Three items of destination information are shown below.
¢
Nickname
¢
E-mail address
¢
Attach log file
Table 2-130 Web console operation
Item Operation
Displaying/setting e-mail
notification
Administration
tab > E-Mail Notification >
Notification Settings tab
Displaying/setting e-mail
destinations
Administration tab > E-Mail Notification >
Destinations Settings tab
Table 2-131 CLI console command
Item Command
Displaying setting for E-mail show e-mail mgmt-lan
Setting notification information by E-mail set e-mail mgmt-lan notification
Setting/adding destination address set e-mail mgmt-lan address
Deleting destination address delete e-mail mgmt-lan address
2-242
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide