Hitachi Compute Blade 500 Series - Page 254

DCMI command NetFn CMD
Min Privilege
level
Support of
CB 500
Set Management Controller
Identifier String
DCGRP (2Ch, 2Dh) 0Ah Admin Y
Get Asset Tag DCGRP (2Ch, 2Dh) 06h User Y
Set Asset Tag DCGRP (2Ch, 2Dh) 08h Operator Y
Get Device ID App (06h) 01h User Y
Get System GUID App (06h) 37h User Y
Get Chassis Capabilities Chassis (00h) 00h User Y
Get Chassis Status Chassis (00h) 01h User Y
Chassis Control Chassis (00h) 02h Operator Y
Chassis Identify Chassis (00h) 04h Operator Y
Get ACPI Power State App (06h) 07h User Y
Set System Boot Options Chassis (00h) 08h Operator
N
1
Get System Boot Options Chassis (00h) 09h Operator Y
Get SEL Info Storage (0Ah) 40h User Y
Reserve SEL Storage (0Ah) 42h User Y
Get SEL Entry Storage (0Ah) 43h User Y
Clear SEL Storage (0Ah) 47h Operator Y
Get DCMI Sensor Info DCGRP (2Ch, 2Dh) 07h Operator Y
Get SDR Repository Info Storage (0Ah) 20h Operator Y
Reserve SDR Repository Storage (0Ah) 22h Operator Y
Get SDR Storage (0Ah) 23h User Y
Get Sensor Threshold S/E (04h) 27h Operator Y
Get Sensor Reading S/E (04h) 2Dh User Y
Set Sensor Event Enable S/E (04h) 28h Operator N
Get Sensor Event Enable S/E (04h) 29h User N
Get Power Reading DCGRP (2Ch, 2Dh) 02h User Y
Get Power Limit DCGRP (2Ch, 2Dh) 03h User Y
Set Power Limit DCGRP (2Ch, 2Dh) 04h Operator Y
Activate/Deactivate Power
Limit
DCGRP (2Ch, 2Dh) 05h Operator Y
Set Thermal Limit DCGRP (2Ch, 2Dh) 0Bh Operator Y
Get Thermal Limit DCGRP (2Ch, 2Dh) 0Ch User Y
Get Temperature Readings DCGRP (2Ch, 2Dh) 10h User Y
Reset Watchdog Timer App (06h) 22h Operator Y
2-230
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide