Hitachi Compute Blade 500 Series - Page 149

6. Select LPAR manager firmware in LP firmware version, and then click
Next.
Tip: It is recommended that LPAR manager configuration information is
backed up before changing LPAR manager firmware assigned to a server
blade.
When LPAR manager configuration information is backed up before this
change, it can be recovered if there are failures or errors occurring on the
LPAR manager firmware after the change.
However, when LPAR manager configuration information is not backed up
before this change, it cannot be recovered.
When LPAR manager configuration information is backed up, move onto
Step 4.
However, when LPAR manager configuration information is not backed up,
move onto Step 6.
7. Click Backup.
Functional detail
2-125
Hitachi Compute Blade 500 Series Management Module Setup Guide