Item Description
PDU rating
current
Setting the rating of input current for PDU.
•
100VAC : not supported
• 200-240VAC : 15A – 100A
(default : 24A)
Number of
PDU
Setting the number of PDU.
• 0/1/2
(default=2: for N+N power supply
module configuration, or four power
supply modules are installed.
default=1: for N+1 or N+0 configuration)
Enable/Disable EPC for
server blade
Selecting server blades for power capping
(EPC):
Disable
Enable (default)
Do not disable this setting.
Accurate
power
control (APC)
Maximum power
consumption
Setting maximum power consumption in
operation.
The specified value must be no more than the
maximum power supply of the system unit
and no less than the minimum power
consumption of the system unit.
The factory default at shipping is the
maximum power supply of the system unit.
The minimum power consumption of the
system unit is the total power ratings of
embedded modules, which includes the
maximum power consumption when capping
to the minimum value for APC-enabled server
blades.
Enable/Disable APC for
server blade
Selecting server blades for power capping
(APC).
In SMP configuration, each server blade
operates with the primary server blade
settings. You need not to perform setting for
non-primary server blades.
The factory default at shipping is Enable.
Changing this value will change the minimum
power consumption of the system unit. The
maximum power consumption is not allowed
to be below the minimum power consumption
of the system unit.
DCMI mode
settings
Enabling and disabling the
DCMI mode for the entire
server chassis
Enables or disables the DCMI mode for the
entire server chassis.
In the initial settings (the settings at shipping
time), the setting is Disable.
You can enable or disable the DCMI mode
only when all server blades that support DCMI
2-214
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide
To Next Page
Loading...
