Hitachi Compute Blade 500 Series - Page 313

8. When the management firmware upload is executed and the upload
progress bar reaches to the right end. Then, the update starts being
executed to show the update progress bar. An update progress bar
indicates the progress of a currently executed update. Wait for about ten
minutes or more until updating finishes.
Upload progress bar
Update progress bar
9. When the update progress bar reaches to the right end, the updating
finishes. Click Close. Dialog messages are different depending on
whether the management module is updated or not.
When the management module is updated:
Tip: The active management module may be rebooted due to update
completion before the message above appears.
In the case above, a message "Request timed out" is displayed. If so,
check the version following steps in (4) Checking new versions about 10
Functional detail
2-289
Hitachi Compute Blade 500 Series Management Module Setup Guide