Hitachi Compute Blade 500 Series Management Module Setup Guide

Setting connection procedure ....................................................................... 2-15
IP address
.................................................................................................. 2-18
Network re-configuration after management module failure ............................ 2-24
Link Fault Tolerance (LFT) ............................................................................ 2-25
Security ............................................................................................................ 2-26
Features and protocol provided by management module and BMC .................. 2-27
Security strength ......................................................................................... 2-29
Security strength and features ...................................................................... 2-31
Feature comparison by the Security strength ................................................. 2-33
TLS/SSL version settings .............................................................................. 2-36
IP address restriction ................................................................................... 2-38
Authentication encryption setting .................................................................. 2-39
System unit settings ........................................................................................... 2-40
Chassis ID ................................................................................................... 2-40
Language .................................................................................................... 2-41
Power supply control .......................................................................................... 2-41
Turning on system unit ................................................................................ 2-42
Turning off system unit ................................................................................ 2-42
Operating power supply for server blade ....................................................... 2-42
Operating power supply for switch module .................................................... 2-43
Server blade operation setting when power failure recovery ........................... 2-43
Remote control for server blade .......................................................................... 2-44
Using remote console .................................................................................. 2-44
Using OS console ......................................................................................... 2-45
Preparation for using OS console .................................................................. 2-45
OS console operations ................................................................................. 2-47
Restriction for using OS console ................................................................... 2-47
Identification LED (LID) operation ....................................................................... 2-48
Each module configuration ................................................................................. 2-50
Configurable modules from management module .......................................... 2-50
Server blade (BMC settings) ......................................................................... 2-52
Server blade (UEFI settings) ......................................................................... 2-53
Hitachi LAN switch module settings ............................................................... 2-53
Hitachi Fibre Channel mezzanine card settings ............................................... 2-53
WWN and MAC addresses .................................................................................. 2-54
Various WWN and MAC addresses ................................................................ 2-54
Selecting WWN and MAC addresses in basic mode ......................................... 2-57
Selecting WWN and MAC address in LP mode ................................................ 2-58
Relation between N+M cold standby and WWN and MAC address ................... 2-58
Initializing Optional Physical WWN and MAC address ...................................... 2-59
Confirmation for WWN and MAC address ....................................................... 2-59
Change log for Optional Physical WWN and MAC address ............................... 2-62
Viewing the host information of the server blade .................................................. 2-63
ServerConductor/Blade Server Manager ............................................................... 2-65
BSM setting ................................................................................................. 2-65
HCSM linkage .................................................................................................... 2-66
HCSM discovery ........................................................................................... 2-67
HCSM options .............................................................................................. 2-67
N+M cold standby ............................................................................................. 2-69
N+M cold standby overview ......................................................................... 2-69
N+M cold standby structure ......................................................................... 2-71
HA monitor linkage ............................................................................................ 2-87
iv
Hitachi Compute Blade 500 Series Management Module Setup Guide

Hitachi Compute Blade 500 Series Specifications

General

Brand	Hitachi
Model	Compute Blade 500 Series
Category	Server
Language	English