EasyManua.ls Logo

Hitachi Compute Blade 500 Series - Page 52

Hitachi Compute Blade 500 Series
362 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Feature
Supported
protocol
Default
port No.
Cipher-
text or
cleartext
Service
disabled
Restriction
on IP
address
Changing
port
number
Remarks
HA monitor
linkage
Hitachi
protocol
Notes
14
clear
Y
15
- Y
RADIUS
authentication
RADIUS 1812
clear
16
Y
3
- Y
Syslog transfer SYSLOG
514
9
cipher/
clear
5
Y
3
- Y
Legend:
Y: Configurable Blank: Not configurable
Notes:
1. Connections from all IP addresses are not allowed, while the port is open.
2. Connection using SSH version 1 is not supported.
3. This protocol can be disabled by disabling the feature. No communication is performed to the port.
4. This protocol can be disabled by disabling the feature. The port is open.
5. You can select ciphertext or cleartext by setting.
6. This protocol can be disabled by disabling the feature or HTTPS itself. The port is open.
7. Registering no management server can disable the protocol. The port itself is isolated.
8. Registering no management server can disable the protocol. No communication is performed to the
port.
9. Destination port for communication with the management module.
10. The connection with the Web console might be disabled.
11. Specify together with the SSH service settings.
12. Must be set for both the IPv4 network and the IPv6 network.
13. If IPv6 addresses are used for HTTPS access, a certificate error (warning) is displayed.
14. The port number is not set by default. When using the HA monitor, the user sets the port number.
15. This protocol can be disabled by disabling the feature. The port itself is isolated.
16. The user password is encrypted, and notification is sent to RADIUS servers.
Tip: [Management module firmware version A0205 or later]
When LPAR manager supports encrypted communication, control
communication between the management module and LPAR manager is
encrypted.
Table 2-34 Features and protocol provided by BMC
Feature
Supported
protocol
Default
port
No.
Cipher-
text or
cleartext
Service
disabled
Restriction
on IP
address
Changing
port
number
Server blade
Web console
HTTPS
1
443 cipher Y Y -
IPMI over LAN IPMI v1.5 623 clear Y Y -
IPMI v2.0 623 cipher Y Y -
2-28
Functional detail
Hitachi Compute Blade 500 Series Management Module Setup Guide

Table of Contents

Other manuals for Hitachi Compute Blade 500 Series

Related product manuals