Hitachi Compute Blade 500 Series - Page 85

Table 2-71 CLI console command
Item Command
Displaying the Default Physical WWN
Show wwn original
Displaying the currently used WWN
Show wwn current
Displaying the Default Physical MAC address
Show mac original
Displaying the currently used MAC address
Show mac current
Tip:
•
For Emulex 10 Gb CNA mezzanine card and the onboard CNA, the
following WWN addresses are shown on the Web console or CLI console.
View on the Web console or CLI console (Emulex 10 Gb CNA
mezzanine card / onboard 2-port CNA)
Port shown
on the
console
World Wide Port Name World Wide Node Name
0 World Wide Port Name for port 0 of
controller 0
World Wide Node Name for port 0
of controller 0
1 World Wide Port Name for port 1 of
controller 0
World Wide Node Name for port 1
of controller 0
2 World Wide Port Name for port 0 of
controller 1
World Wide Node Name for port 0
of controller 1
3 World Wide Port Name for port 1 of
controller 1
World Wide Node Name for port 1
of controller 1
View on the Web console or CLI console (Emulex 10 Gb CNA onboard
4-port CNA)
Port shown
on the
console
World Wide Port Name World Wide Node Name
0 World Wide Port Name of port 0 of
controller 0
World Wide Node Name of port 0 of
controller 0
1 World Wide Port Name of port 1 of
controller 0
World Wide Node Name of port 1 of
controller 0
2 World Wide Port Name of port 2 of
controller 0
World Wide Node Name of port 2 of
controller 0
3 World Wide Port Name of port 2 of
controller 0
World Wide Node Name of port 2 of
controller 0
- Since the onboard CNA (2 ports) has one controller, Current WWN and
Default Physical WWN for port 2 and port 3 are not shown on the console.
Functional detail
2-61
Hitachi Compute Blade 500 Series Management Module Setup Guide