Hitachi PB - Charge Voltage Fault

6-12
 6.2.9 Charge Voltage Fault


Charge Voltage
Fault
Connect the connector.
Disconnect the connector and then
reconnect it.
Does the printer
become ready for
printing?
Y
es
No
END
Y
es
No
Replace the high-voltage
power supply unit.
Does the printer
become ready for
printing?
Y
es
No
END
Does the printer
become ready for
printing?
Y
es
No
Replace the EZJ93 board.
END
Replace the EZJ94 board / EZJ106 board.
Is the EZJ94 board / EZJ106 board
CN6 connector or high-voltage power
supply CN1 connector disconnected?