Hitachi PB - Print Data Changeover in Progress S,C,M,V; Target Frequency too High

6-25

  6.3.4 Target Frequency Too High

  6.3.5 Print Data Changeover In Progress S,C,M,V
Target Frequency
Too High
Is the sensor chattering?
Ensure that the sensor does
not chatter.
Y
es
No
A
re there more than four
workpieces (print targets)
between the sensor and
print head?
No
Replace the EZJ93 board.
Decrease the clearance
between the sensor and
print head and reduce the
number of workpieces
between the sensor and
print head to four or less.
Y
es
The print target detection signal entered while the printer was not
ready. See that the print target detection signal enters after a while.
SUPPLEME
Print Data Changeover
In Progress
Resume the
operation.