Hitachi PB - Improper Sensor Position

6-24

  6.3.3 Improper Sensor Position

Is there an excessive
clearance between the
print head and print target
detector?
Y
es
Improper sensor position
Is the continuous printing
function required?
No
Set the “Continuous
printing count” to
“0000”.
Replace the EZJ93 board.
Y
es
No
Resume the
operation.
Decrease the
clearance between
the print head and
print target
detector.
Y
es
Ensure that the print
start signal does not
chatter any longer.
Y
es
No
Is the print start signal
chattering?
No
Is the “Continuous
printing count” is set
to “0000”from the
print specifications
screen?