Hitachi PB - Battery Low; Product Speed Matching Error

6-33

6.4.4 Battery Low

6.4.5 Product Speed Matching Error
Battery Low
Resume the
operation.
Is the EZJ102 board
CN2 connector
disconnected or in
poor contact?
Y
es
No
Replace the battery.
Normality is restored when
the connector is disconnected
and then reconnected.
Product Speed
Matching Error
Resume the
operation.
The frequency of the speed- follow-up signal (encoder
signal) is exceeding the printing capability of the IJ printer.
Lower the frequency of the speed- follow-up signal, or
increase its dividing ratio. Note that the printed character
width will change if the dividing ratio is changed.
See 1.5.3-6 ”Rotary encoder signal input” in the Instruction
manual.