Hitachi PB - Page 148

6-44
6.5.7 Printing initiation failure in
ready-for-printing state (no prints)
No prints
Check the print
target detector
wiring and supply
voltage and enter
the print start
signal to the IJ
printer.
Is the printer in
the “Ready”
state?
Is the encoder
signal properly
entered?
Optimize the write
start position
setting.
Properly enter the
encoder signal.
Connect the cable.
Is the “Product
speed matching”
feature is set to
“Provided” from
the IJ printer
screen?
Resume the
operation.
Replace the EZJ93
board.
Is the high-
voltage cable
disconnected?
Replace the EZJ102
board.
Y
es
Y
es
Does the obtained
print consist of
spaces only?
No
No
No
Is the cable
between CN7 on
EZJ93 board and
CN9 on EZJ102
board
disconnected?
Y
es
No
Place the printer in
The “Ready” state.
No
Y
es
Y
es
No
Y
es
No
Is the write
start position
setting
p
ro
p
er?
Are prints made?
No
Y
es
Are prints made?
No
Y
es
Are prints made?
No
Y
es
Y
es
No
Are prints made?
Y
es
Enter characters
other than a
space.
No
Are prints made?
Is the print start
signal entered?
Connect the cable.
Y
es
Y
es
No
Y
es
No
Are prints made?
Is the cable
between CN10 on
EZJ102 board
and CN1 on
EZJ103 board
disconnected?
Connect the cable.
Are prints made?
No
Y
es