122
On-Screen Setup Menus
Note It is necessary to position the camera so the area to be covered by the Privacy
Zone is viewed on the monitor prior to accessing the on-screen setup menus.
1. Move the joystick down until 6 Program Privacy Zone is highlighted, and then
press Iris Open.
2. Move the joystick up until the desired Privacy Zone number (1–32) displays. Move the
joystick left and right to move between the digits, if necessary.
3. Press Iris Open.
4. Move the joystick up or down to enter a 24-alphanumeric name for the Privacy Zone.
This name displays on the video whenever the ACUIX is viewing any portion of the
Privacy Zone. Move the joystick left or right to position the cursor.
5. When the desired name displays, press Iris Open.
6. Move the joystick up and down to increase or decrease the height of the Privacy Zone
box and the left and right to increase or decrease the width of the box.
7. When the box is the desired size, press Iris Open.
8. Program another Privacy Zone or press Iris Close to exit programming.
Delete PS/PT/PZ/Sectors (Honeywell VCL and Supported 3rd
Party Protocols)
This menu option is only displayed when the ACUIX DIP switches are set to Honeywell VCL,
Pelco P, or Pelco D protocol. When set to Honeywell Standard protocol, this option is NA
(not applicable). See Program Preset Menu Commands, page 39, in Chapter 3, Operation
and Programming with Honeywell Diamond Protocol for more information on deleting
Presets, Preset Tour Commands, page 44, in Chapter 3 for more information on deleting
Preset Tours, Sector ID Commands, page 50, in Chapter 3 for more information on deleting
Sector IDs, and Privacy Zones, page 51, in Chapter 3 for more information on deleting
Privacy Zones.
From this option, Presets, Preset Tours, Privacy Zones, and Sectors can be deleted.
1. Move the joystick down until 7 Delete
PS/PT/PZ/Sector is highlighted, and
then press Iris Open.
2. Press Focus Near until the desired
function (Privacy Zone, Preset, Preset
Tour, or Sector) displays.
3. Move the joystick up or down until the
desired number displays. Move the
joystick left and right to move between
the digits, if necessary.
4. Press Iris Open. If deletion of the programming was successful, the message
Delete Success displays on the monitor. If that function (Preset, Preset Tour,
Privacy Zone, or Sector) was not programmed, it cannot be deleted, and the message
Does Not Exist displays on the monitor.
Delete Privacy Zone # --
Focus Near to change options:
ESC to Exit
To Next Page
Loading...
