Cut Along the Dotted Line
P/N LS10163-001SK-E Rev A ECN: 16-0218
Figure 1-2: Gain ECS Control as ECS Super User Screen
How to Operate the Microphone:
1. Press the ECS Control Button
2. Key the Microphone
3. Press the All Call Button
How to Reset the ECS System
1. Press The Reset Button
2. Select 2 Reset emergency System
ECS-RPU Operating Instruction
For Live Message
1. Key the Microphone.
2. Press the All Call Key or select desired output area using Select Keys.
3. Deliver your verbal message.
For Pre-recorded Message
1. Select desired ECS Message Key 1-8.
• If ECS Control LED is on steady, the LOC has ECS Control.
• If ECS Control LED is Blinking, another LOC has ECS Control.
Table 1-2: ECS Control Request
Operation Task
Gain ECS Control at an LOC Press the ECS Control Key and enter a code if prompted. If ECS
Control is available, the ECS Control LED will illuminate. If another
LOC has ECS Control, the display will be similar to the one shown.
Press 1 to request control. The LOC with ECS Control will then be able
to allow or deny the request.
Gain ECS Control as ECS Super User at an LOC
(only one ECS Super User is allowed ECS Control
in the system at a time).
From the idle screen, enter an ECS Super User access code and then
press the ECS Control Key. If ECS Control as Super User is available,
the ECS Control LED will illuminate. If another LOC has Super User
ECS Control, a request for Super User ECS Control will automatically
be made to the LOC with control. The LOC with Super User ECS
Control will then be able to allow or deny the request. (See Figure 1-2
for screen display example).
Select all output group for microphone override Key the microphone, wait for the Ready-to-Talk LED to light, press the
All Call Key, and then deliver your verbal message.
Select all non-activated output groups for
microphone override
Key the microphone, wait for the Ready-to-Talk LED to light, press the
Non-Active Call Key, and then deliver your verbal message.
To Next Page
Loading...
