HP 1660 Series Training Guide

Introduction to Inverse Assembly
An inverse assembler translates the captured data into
microprocessor instructions.
To perform inverse assembly, you must probe a microprocessor and
load the correct configuration and inverse assembler. The training
board does not have a microprocessor. Therefore, for these exercises
you will load a sample listing to simulate the captured microprocessor
instructions.
In this chapter you will:
• Load the inverse assembler and sample listing
• View the address, data, and status labels
• View the assembly listing
• Filter the captured data
10-2
Get other manuals https://www.bkmanuals.com

HP 1660 Series Specifications

General

Category	Logic Analyzer
Glitch Trigger	Yes
Pattern Trigger	Yes
State Analysis	Yes
Transitional Timing	Yes
Trigger Modes	Edge, Pattern, Glitch