HP 1660 Series - Enable Time Correlation between the Timing and State Analyzers

Enable Time Correlation between the Timing and
State Analyzers
Setting the Count to Time causes the state analyzer to store a time value,
called a time stamp, for each data point that is stored in memory. When the
mixed display is selected, the time stamp information is used to display the
data in both the timing and state displays with the proper time relationship
(correlation).
1
Highlight the Count Off field, and press the Select key.
2 In the pop-up menu, highlight the field to the right of Count, and press
the
Select key.
3 Highlight Time in the next pop-up menu, and press the Select key.
Press the
Done key to close the Count pop-up menu.
Data stored before triggering has negative time numbers, and data stored
after triggering has positive time numbers.
Enabling Time Correlation between the Timing and State Analyzers
Result The state analyzer is set to store a time stamp for each state that is recorded.
A time stamp does not have to be set for the timing analyzer because the
timing analyzer automatically keeps track of time.
The Count field
accesses a selection
menu which indicates
whether acquisition
data is stamped with
a Time tag or a State
Count tag.
Count Time places time
tags on all displayed
data.
Mixed Mode - Correlation of State and Timing Data
Enable Time Correlation between the Timing and State Analyzers
5-8
Get other manuals https://www.bkmanuals.com